Поставка оптоэлектронных компонентов ведущих мировых производителей

The HTMA series is a range of modified atmosphere high temperature ovens for use with inert atmospheres up to 700°C. Separate flow controls for purge and process gases mean that once the chamber has been purged of atmospheric air process gas can be used with lower flow rates. Switching between purge and process gases can either be done manually or by adding the option of an automatic programmable control system. Oxygen levels down to 50 ppm are achievable. Standard features Carbolite Gero 301 controller, with single ramp to set-point & process timer Rear mounted fan & side air guides give horizontal ‘airflow’ Fully seam welded to contain modified atmosphere Manual gas control via needle valves & flowmeters (nickel brass) Corrosion resistant stainless steel interior with perforated non-tip shelves & runners Stainless steel pipe-work, nickel brass flow-meter & solenoid valves Single side hinged door, with metal heat seal & rubber gas tight seal, closed using non slam handle Hard wearing, zinc coated & stoved epoxy polyester coated exterior Gas inlet connection: bulkhead compression fitting to suit 10 mm outside diameter tube (maximum inlet pressure = 2 bar) Door switch Options (specify these at time of order) Automatic gas control (requires a 3508 series programmable controller) A range of sophisticated digital controllers, multi-segment programmers and data loggers is available. These can be fitted with RS232, RS485 or Ethernet communications Stainless steel flow-meter & solenoid valves, instead of nickel brass Fixed or castor mounted floor stands Flow failure alarm

Технические характеристики

CharacteristicsFunctionheat treatmentConfigurationchamberHeat sourcegasAtmosphereinert gasOther characteristicsinox, digital, programmable, horizontal, automaticMaximum temperature

Max.: 700 °C (1,292 °F)

Min.: 60 °C (140 °F)

Capacity

28 l, 95 l, 220 l, 500 l, 1,000 l (7.4 gal)

Width

Max.: 1,530 mm (60.24 in)

Min.: 810 mm (31.89 in)

Height

Max.: 1,310 mm (51.57 in)

Min.: 990 mm (38.98 in)

Depth

Max.: 1,635 mm (64.37 in)

Min.: 885 mm (34.84 in)

HTMA series Heat treatment oven HTMA series, chamber, inert gas. — товар из ассортимента Laserzz для подбора и поставки под задачи ремонта и комплектации.

Позиция подходит для сценариев замены и закупки под конкретную спецификацию оборудования.

Для корректного выбора сверяйте маркировку, параметры и совместимость с вашей схемой/узлом.

Вопросы и ответы

Как проверить совместимость товара?

Сравните артикул, технические параметры и формат исполнения с требованиями вашей модели оборудования.

Можно ли заказать партию?

Да, для партийных закупок доступны отдельные условия, ориентируйтесь на количество и сроки поставки.