Reads all heads: • Power: thermopiles, photodetectors and pyroelectrics • Energy: thermopiles (in single shot mode), photodetectors and pyroelectrics MEASURE FJ ENERGY LEVELS Thanks to a unique digital method for suppressing the noise on the lower ranges EXTERNAL TRIGGER Synchronize your U-LINK to your pulsed laser or digital chopper SERIAL COMMANDS Serial commands are available on both versions to let you take full control REAL-TIME STATISTICAL FUNCTIONS Max, min, average, standard deviation, RMS and PTP stability SYNCHRONIZE MULTIPLE CHANNELS With the ‘SYNC. OUT’ port, you can plug multiple U-LINK devices together and create a low-cost multi-channel system. MAIN CONTROLS Complete and easily navigable software interface with all the necessary options and tools: • Connection: connect or disconnect your device. • Controls: turn the turbo mode on or off, make a zero to remove the thermal offset, start the acquisition of the data and start the calculations of the statistics associated with this data. • Startup config: save your measurements settings or load the settings associated with an already existing file. • Help: get information about the PC-Gentec-EO software and read the user manual. • Measure: configure the parameters related to your measurements. • Display: set the desired number of digits and settings associated with the selected display. • Acquisition: enter the parameters related to the acquisition of data. MEASUREMENT PARAMETERS The measure tab allows you to configure the parameters related to your measurements: • Wavelength: enter the wavelength of your laser and the software will apply the appropriate correction factor on the measurements.
Технические характеристики
CharacteristicsBusUSBOther characteristicspower
