| CE marking | [*PD-Z02585A*] |
| Switching frequency | 0 … 1500 Hz |
| Effective internal capacitance | max. 45 nF ; a cable length of 10 m is considered. |
| Appropriate type | NJ 4-12GM-N… |
| Mission Time (TM) | 20 a |
| MTTFd | 11774 a |
| Connection type | cable PVC , 2 m |
| Degree of protection | IP68 |
| Effective internal capacitance | max. 45 nF ; a cable length of 10 m is considered. |
| Output type | NAMUR |
| Core cross-section | 0.34 mm2 |
| Output type | 2-wire |
| Standards | EN 60079-0:2012+A11:2013 EN 60079-11:2012 Ignition protection «Intrinsic safety» Use is restricted to the following stated conditions |
| CE marking | [*PD-Z02585A*] |
| Maximum permissible ambient temperature | Details of the correlation between the type of circuit connected, the maximum permissible ambient temperature, the surface temperature, and the effective internal reactance values can be found on the EC-type-examination certificate. The maximum permissible ambient temperature of the data sheet must be noted, in addition, the lower of the two values must be maintained. |
| Appropriate type | NJ 4-12GM-N… |
| CCC approval | CCC approval / marking not required for products rated ≤36 V |
| CSA approval | cCSAus Listed, General Purpose |
| Rated operating distance | 4 mm |
| Standards | EN 60079-0:2012+A11:2013 EN 60079-11:2012 Ignition protection «Intrinsic safety» Use is restricted to the following stated conditions |
| Nominal voltage | 8.2 V (Ri approx. 1 kΩ) |
| Sensing face | PBT |
| Switching function | Normally closed (NC) |
| ATEX marking | |
| Effective internal inductance | max. 50 µH ; a cable length of 10 m is considered. |
| ATEX marking | |
| Maximum permissible ambient temperature | Details of the correlation between the type of circuit connected, the maximum permissible ambient temperature, the temperature class, and the effective internal reactance values can be found on the EC-type examination certificate. |
| Appropriate type | NJ 4-12GM-N… |
| ATEX marking | |
| Standards | EN 60079-0:2012+A11:2013 EN 60079-11:2012 Ignition protection «Intrinsic safety» Use is restricted to the following stated conditions |
| Effective internal inductance | max. 50 µH ; a cable length of 10 m is considered. |
| Diagnostic Coverage (DC) | 0 % |
| Ambient temperature | -25 … 100 В°C (-13 … 212 В°F) |
| CE marking | [*PD-Z02585A*] |
| Housing material | Stainless steel 1.4305 / AISI 303 |
| Ambient temperature | Details of the correlation between the type of circuit connected, the maximum permissible ambient temperature, the temperature class, and the effective internal reactance values can be found on the EC-type examination certificate. Note: Use the temperature table for category 1 !!! The 20 % reduction in accordance with EN 1127-1 has already been applied to the temperature table for category 1. |
| Reduction factor rCu | 0.3 |
| Use in the hazardous area | see instruction manuals |
| Assured operating distance | 0 … 3.24 mm |
| Installation | non-flush |
| Effective internal inductance | max. 50 µH ; a cable length of 10 m is considered. |
| Effective internal capacitance | max. 45 nF ; a cable length of 10 m is considered. |
| Reduction factor rAl | 0.4 |
| Reduction factor r304 | 0.85 |
| Hysteresis | 3 % |
| Частота переключения | 0 … 1500 Гц |
|---|---|
| Эффективная внутренняя емкость | max. 45 nF ; a cable length of 10 m is considered. |
| Соответствующий тип | NJ 4-12GM-N… |
| Время эксплуатации (TM) | 20 a |
| MTTFd | 11774 a |
| Тип разъема | кабель ПВХ, 2 м |
| Степень защиты | IP68 |
| Тип выхода | 2-проводный |
| Сечение проводника | 0.34 мм² |
| Стандарты | EN 60079-0:2012+A11:2013 EN 60079-11:2012 Ignition protection ""Intrinsic safety"" Use is restricted to the following stated conditions |
| Маркировка CE | [*PD-Z02585A*] |
| Максимальная допустимая температура окружающей среды | Сведения о соответствии между типом подключенной цепи, максимально допустимой температурой окружающей среды, температурным классом и значениями эффективной внутренней реактивности можно найти в сертификате ЕС об испытаниях типа. |
| Одобрение CCC | Сертификация/маркировка CCC не требуется для продуктов с номинальным напряжением ≤36 В |
| Сертификация CSA | cCSAus Listed, General Purpose |
| Номинальное рабочее расстояние | 4 мм |
| Номинальное напряжение | 8,2 В (R<sub>i</sub> примерно 1 кОм) |
| Зонд ближнего действия | PBT |
| Функция переключения | Нормально замкнутый (NC) |
| Маркировка ATEX | II 1G Ex ia IIC T6…T1 Ga Маркировка, относящаяся к взрывозащите, может также быть нанесена на прилагаемую этикетку. |
| Эффективная внутренняя индуктивность | макс. 50 µH ; рассматривается длина кабеля 10 м. |
| Покрытие диагностики (DC) | 0 % |
| Температура окружающей среды | Details of the correlation between the type of circuit connected, the maximum permissible ambient temperature, the temperature class, and the effective internal reactance values can be found on the EC-type examination certificate. Note: Use the temperature table for category 1 !!! The 20 % reduction in accordance with EN 1127-1 has already been applied to the temperature table for category 1. |
| Housing material | Нержавеющая сталь 1.4305 / AISI 303 |
| Коэффициент редукции rCu | 0.3 |
| Использование во взрывоопасной зоне | см. инструкции по эксплуатации |
| Гарантированное рабочее расстояние | 0 … 3,24 мм |
| Монтаж | незаподлицо |
| Коэффициент редукции rAl | 0.4 |
| Коэффициент редукции r304 | 0.85 |
| Гистерезис | 3 % |
NJ4-12GM-N-Y19785 Пепперл+Фукс NJ4-12GM-N-Y19785 — товар из ассортимента Laserzz для подбора и поставки под задачи ремонта и комплектации.
Позиция подходит для сценариев замены и закупки под конкретную спецификацию оборудования.
Ключевые параметры: Частота переключения: 0 ... 1500 Гц; Эффективная внутренняя емкость: max. 45 nF ; a cable length of 10 m is considered.; Соответствующий тип: NJ 4-12GM-N...; Время эксплуатации (TM): 20 a; MTTFd: 11774 a.
Для корректного выбора сверяйте маркировку, параметры и совместимость с вашей схемой/узлом.
Вопросы и ответы
Как проверить совместимость товара?
Сравните артикул, технические параметры и формат исполнения с требованиями вашей модели оборудования.
Можно ли заказать партию?
Да, для партийных закупок доступны отдельные условия, ориентируйтесь на количество и сроки поставки.







