| UL File Number | E223772 |
| LED AS-i ACTIVE | AS-Interface operation normal; LED green |
| LED CONFIG ERR | configuration error; LED red |
| AS-Interface specification | V3.0 |
| Construction type | Low profile housing, Stainless steel |
| LED PRG ENABLE | autom. programming; LED green |
| AS-Interface | spring terminals, removable |
| Storage temperature | -25 … 85 °C (-13 … 185 °F) |
| Display | Illuminated graphical LC display for addressing and error messages |
| Earth fault detection | integrated |
| Switch SET | Selection and setting of a slave address |
| LED U AS-i | AS-Interface voltage; LED green |
| Transfer rate | 9.6 kBit/s / 12 MBit/s, Automatic baud rate detection |
| Rated operating voltage | from AS-Interface |
| Diagnostics function | Extended function via display |
| Interface type | RS-485 |
| OK button | Mode selection traditional-graphical/confirmation |
| Button | 4 |
| Mass | 460 g |
| PROFIBUS | Sub-D interface |
| ESC button | Mode selection traditional-graphical/cancel |
| LED PROFIBUS | PROFIBUS master detected; LED green |
| Insulation voltage | 500 V |
| Protocol | PROFIBUS in accordance with IEC 61158/IEC 61784-1 |
| Rated operating current | approx. 200 mA from AS-Interface |
| EMC monitoring | integrated |
| Degree of protection | IP20 |
| Button MODE | Mode selection PRJ-operation/save configuration/cursor |
| Ambient temperature | 0 … 55 °C (32 … 131 °F) |
| AS-Interface | EN 62026-2:2013 |
| Degree of protection | EN 60529:2000 |
| LED POWER | voltage ON; LED green |
| LED PRJ MODE | projecting mode active; LED yellow |
This device is characterized by its UL File Number E223772. The AS-i ACTIVE LED indicates normal AS-Interface operation with a green light, while the CONFIG ERR LED signals a configuration error with a red light.
The AS-Interface specification is V3.0. The construction type is a low profile housing made of stainless steel. The PRG ENABLE LED indicates automatic programming when lit green. The AS-Interface connection uses spring terminals that are removable.
Storage temperature ranges from -25 to 85 °C (-13 to 185 °F). The device features an illuminated graphical LC display for addressing and error messages. Earth fault detection is integrated. The SET button is used for selection and setting of a slave address. The U AS-i LED indicates AS-Interface voltage with a green light.
The transfer rate is 9.6 kBit/s or 12 MBit/s, with automatic baud rate detection. The rated operating voltage is supplied from AS-Interface. Diagnostics functions are extended via the display. The interface type is RS-485.
There are four buttons: OK button for mode selection (traditional-graphical/confirmation), ESC button for mode selection (traditional-graphical/cancel), and MODE button for mode selection (PRJ-operation/save configuration/cursor). The mass of the device is 460 g.
The PROFIBUS interface is a Sub-D connector. The insulation voltage is 500 V. The protocol is PROFIBUS in accordance with IEC 61158/IEC 61784-1. The rated operating current is approximately 200 mA from AS-Interface. EMC monitoring is integrated. The degree of protection is IP20.
The device complies with AS-Interface standard EN 62026-2:2013 and degree of protection standard EN 60529:2000. The POWER LED indicates voltage ON with a green light. The PRJ MODE LED indicates that projecting mode is active with a yellow light.
