The UC250-F77-EP-IO-V31 is a sensor with integrated IO-Link communication. It has a detection range and environmental tolerance suitable for industrial applications. The sensor is designed for automation tasks requiring accuracy and reliability.
| IO-Link Revision: 1.1 | |
| Transfer rate: COM 2 (38.4 kBaud) | |
| Temperature influence: ±0.75 % of the end value (with temperature compensation) | |
| No-load supply current: 40 mA | |
| Storage temperature: -40 … 85 °C (-40 … 185 °F) | |
| Min. cycle time: 2.3 ms | |
| Response delay: minimum: 8 ms factory setting: 29 ms | |
| Dead band: 0 … 20 mm | |
| Operating voltage: 10 … 30 V DC, ripple 10 %SS | |
| Write cycles: 300000 | |
| Installation position: any position | |
| CCC approval: CCC approval / marking not required for products rated 36 V | |
| Output type: 1 push-pull (4 in 1) output, short-circuit protected, reverse polarity protected | |
| UL approval: cULus Listed, Class 2 Power Source | |
| SIO mode support: yes | |
| LED red: solid: error | flashing: switch point programming, object not detected |
| Ambient temperature: -25 … 70 °C (-13 … 158 °F) | |
| LED green: solid: Power on | flashing: Standby mode or IO-Link communication |
| Sensing range: 20 … 250 mm | |
| Repeat accuracy: ±0.1 % of full-scale value | |
| Adjustment range: 25 … 250 mm | |
| Connection type: Connector plug M8 x 1, 4-pin | |
| Compatible master port type: A | |
| Standard target plate: 10 mm x 10 mm | |
| Range hysteresis: 1 % of the adjusted operating range (default settings), programmable, min. 1 mm | |
| Transducer frequency: approx. 400 kHz | |
| Non-volatile memory: EEPROM | |
| Sensor cycle time: 8 ms (factory setting); programmable to 60 s | |
| Mass: 9 g | |
| Beam width: wide | |
| LED yellow: solid: object in evaluation range | flashing: switch point programming, object detected |
| Rated operating current: 100 mA, short-circuit/overload protected | |
| Device ID: 0x300300 (3146496) | |
| Process data width: 16 bit | |
| Input/output type: 1 synchronization connection, bidirectional | |
| Output: near switch point: 25 mm far switch point: 250 mm Output mode: Window mode Output logic: normally open | |
| Tightening torque, fastening screws: max. 0.2 Nm | |
| Interface type: IO-Link (via C/Q = Pin 4) | |
| Voltage drop: 2.5 V | |
| Device profile: Smart Sensor | |
| Time delay before availability: 300 ms | |
| Switching frequency: factory setting: 20 Hz; programmable max. 45 Hz | |
| Degree of protection: IP67 | |
| Power consumption: 400 mW |
