The M-ST-46-12 Fully Integrated SmartTable incorporates factory installed IQ dampers. This 305 mm thick optical table has a 1200 mm width, 1800 mm length, and Metric M6 holes on a 25 mm grid. M-ST Series SmartTables incorporate Newports patent pending intelligent Q (IQ) damping technology to actively monitor, report, and adjust table-damping performance over a wide frequency band. This provides a dramatically quieter table surface, resulting in high quality imaging, improved long term stability, faster settling times and the ability to make measurements that previously required the quietest lab environments. SmartTable also allows users to monitor tabletop vibrations through built in vibration sensors that provide real time feedback on the vibration state of the table. The included ST-300 SmartTable Controller can be used in a stand-alone (no computer required) mode and is also USB2 compatible. When operating in the stand-alone mode SmartTable automatically tunes the table to maximize table damping independent of load. When connected to a computer via the USB2 port, the included software allows users to further fine tune and calibrate the table to the experiment at hand and gather vibration data in both the frequency and time domains. Isolators are sold separately
Технические характеристики
- Active Damping 2 IQ active dampers
- Structural Damping Range 80-550 Hz
- Broadband Damping Constrained layer core, damped working surface and composite edge finish
- Width 1200 mm
- Length 1800 mm
- Thickness 305 mm
- Working Surface 4.8 mm thick 400 series ferromagnetic stainless steel
- Surface Flatness ± 0.1 mm over 600 mm square
- Mounting Holes M6
- Mounting Hole Pattern 25 mm grid
- Mounting Hole Borders 12.5 mm
- Hole Sealing Type Easy clean conical cup, 19 mm deep, non-corrosive high impact reinforced composite material
- Bottom Skin Material 4.8 mm thick carbon steel
- Core Design Trussed honeycomb, vertically bonded closed cell construction, 0.25 mm steel sheet materials, 0.76 mm triple core interface
- Vibration Monitor Range 10-820 Hz
- Computer Interface USB
- I/O BNC output with sensitivity of 30V/(mm/s), Frequency range of 18-820V, Measurement range of 0-0.16mm/s
- Power Requirements 100-240 VAC, 1.5A, 50/60Hz
- Weight 333 kg
- Crated Weight 410 kg
