Electromagnetic level indicators with double contact or min-empty contact M18x1 5 connection SPST Contacts USE: Made to ensure, with maximum safety, the minimum or and empty levels of liquids in tanks, and hydraulic power packs containing mineral oils with viscosity not higher than 80°E. and for all non-corrosive and inflammable liquids. OPERATION: IEG-TQ10MM: when the float of the indicator encounters the Reed switch incorporated in the tube at the pre-established distances, the contact activated by the magnet housed in the float opens or closes, thus obtaining the possibility of sending a luminous or acoustic signal or disconnecting any electrical equipment connected to it. The levels IEG-TQ10MV are used for having a double alarm signal at a pre-established distance. The former is normally used to signal when the liquid is nearly finished, the latter can be used as a machine stop, etc. The contacts that are activated by a single float can be at least 25 mm apart. Also, the signals (in absence of liquid ) can be activated (they close) consecutively or deactivated (they open). The same principle can be applied for the maximum level control (max. and extra max.). FITTING: The indicator must be fitted in the vertical position, and the float must be at least 35mm from ferrous surfaces (walls, tanks, etc.). The tight‘s flange is ensured by a flat synthetic rubber gasket and by a locking nut. Since the diameter of the float is greater than the diameter of passage hole on the tank during installation you must fix the gauge to the tank and replace the float.
Технические характеристики
CharacteristicsTechnologymagnetic floatMediumfor liquidsApplicationsfor tanksMaterialbrass, aluminumMountingthreaded, verticalOther characteristicsreed switch, IP65Process temperature
Max.: 120 °C (248 °F)
Min.: -20 °C (-4 °F)
Process pressure
Max.: 10 bar (145.04 psi)
Min.: 0 bar (0 psi)
