As fast as a pneumatic cylinder and as strong as a hydraulic one How they Work Pneumo-hydraulic cylinders integrate two components in a single actuator: a pneumatic cylinder and an air/oil pressure intensifier. The pneumatic cylinder is located in the lower part of the unit and allows for rapid approach to the workpiece. The air/oil intensifier is located in the upper part of the unit and allows the pressing of the piece with high force (up to ten times greater than the force that would be obtained with an air cylinder of the same bore). Pneumo-hydraulic cylinders can replace hydraulic cylinders, eliminating the need for a dedicated hydraulic power unit. With 2 models and 9 sizes (thrust force from 5 kN to 419 kN) the pneumohydraulic power units of the AP and AX series offer high productivity at low costs. They use compressed air as the only power source. The approach stroke is completely pneumatic, fast, efficient and inexpensive. Once in contact with the piece, the ingenious air-oil multiplier system develops the force necessary for the actual pressing. Pressings, fittings, deformations, assemblies. Operations that the cylinder performs easily, efficiently, combining the best of pneumatic and hydraulic technologies. The Advantages RELIABLE High quality hydraulic and mechanical seals: these cylinders are built to last. PRODUCTIVE With pneumatically controlled approach and return and hydraulic pressing stroke, they guarantee reduced cycle times for unrivaled yield. REDUCED CONSUMPTION The pneumatic/hydraulic separation limits consumption to the pressing phase only, only when needed. The AP Series The hydropneumatic cylinders of the AP series have an linear .
Технические характеристики
CharacteristicsTypehydro-pneumaticOther characteristicsbending, hydro-pneumatic, rapidStroke
Max.: 215 mm (8.465 in)
Min.: 30 mm (1.181 in)
Force
Max.: 419 kN
Min.: 5.3 kN
Pressure
6 bar (87 psi)
